Rohde & Schwarz R&S CMW-KM300, User Manual, Page: 113 / 388

NB-IoT Signaling
R&S
®
CMW-KM300/-KS300
113 User Manual 1178.5689.02 ─ 06
CALL:NIOT:SIGN<i>:PSWitched:ACTion <PSAction>
Controls the PS state.
Setting parameters:
<PSAction> CONNect | DISConnect | SMS | DETach
CONNect : Set up an RRC connection.
DISConnect : Release the RRC connection.
SMS : Send an SMS
DETach : Detach the UE
Example: See Setting Up a Connection
Usage: Event
Firmware/Software: V3.7.30, V3.7.60: added SMS
Manual operation: See "Connection control hotkeys" on page 42
FETCh:NIOT:SIGN<i>:PSWitched:STATe?
Queries the PS state, see also Chapter 2.2.4, "Connection States" , on page 16.
Return values:
<PS State> OFF | ON | ATTached | CESTablished | DISConnect |
CONNecting | SIGNaling | SMESsage | RMESsage
OFF : signal off
ON : signal on
ATTached : UE attached
CESTablished : Connection established
DISConnect : Disconnect in progress
CONNecting : Connection setup in progress
SIGNaling : Signaling in progress
SMESsage : Sending message
RMESsage : Receiving message
*RST: OFF
Example: See Setting Up a Connection
Usage: Query only
Firmware/Software: V3.7.20, V3.7.60: added SMESsage, RMESsage
Manual operation: See "Packet Switched" on page 34
2.5.3 Event Log
The following commands retrieve event log entries and clear the log.
SENSe:NIOT:SIGN<i>:ELOG:LAST?
................................................................................114
SENSe:NIOT:SIGN<i>:ELOG:ALL?
..................................................................................114
CLEan:NIOT:SIGN<i>:ELOG
........................................................................................... 114
Command Reference
深圳德标仪器
135-1095-0799