Rohde & Schwarz NRPM OTA Power Measurement Solution, Manual

Page: 105 / 229

Network and remote operation
R&S
®
NRPM
105 Mannual 1425.8663.02 ─ 08
Bit No. Meaning
4 Execution error
This bit is set if the syntax of a received command is correct but the command
cannot be executed due to various marginal conditions. An error message with a
number between -200 and -300 denoting the error in greater detail is entered in
the error queue.
5 Command error
This bit is set if an undefined command or a command with incorrect syntax is
received. An error message with a number between -100 and -200 denoting the
error in greater detail is entered in the error queue.
6 User request
This bit is set when the sensor module is switched over to manual control.
7 Power on
This bit is set when the sensor module is switched on.
9.2.8 Operation status register
The
CONDition
register contains information on the operations currently being
performed by the sensor module, while the EVENt register contains information
on the operations performed by the since the last readout of the register.
Querying the register:
●
STATus:OPERation:CONDition?
●
STATus:OPERation[:EVENt]?
Table 9-9: Meaning of bits used in the operation status register
Bit No. Meaning
0 Calibrating status register summary bit
This bit is set if the sensor module is being calibrated.
See
Chapter 9.2.8.1, "Operation calibrating status register" , on page 108.
1 to 3 Not used
4 Measuring status register summary bit
This bit is set if the sensor module is performing a measurement.
See
Chapter 9.2.8.2, "Operation measuring status register" , on page 108.
5 Trigger status register summary bit
This bit is set if the sensor module is in the waiting for trigger state, i.e. waiting for
a trigger event.
See
Chapter 9.2.8.3, "Operation trigger status register" , on page 109.
6 Not used
Status reporting system