Preparing for Use
R&S
®
NRP-Zxx
11
Getting Started 1176.8822.02 ─ 04
4
Preparing for Use
This section describes the basic steps to be taken when setting up the R&S
NRP
‑
Z power sensors for the first time.
Risk of injury due to disregarding safety information
Observe the information on appropriate operating conditions provided in the
data sheet to prevent personal injury or damage to the power sensor. Read
and observe the basic safety instructions provided with the power sensor, in
addition to the safety instructions in the following sections. In particular, do
not open the casing of the power sensor.
Risk of electrostatic discharge
Protect the work area against electrostatic discharge to avoid damage to
electronic components in the modules. For details, refer to the general
safety instructions.
Risk of instrument damage due to inappropriate operating conditions
An unsuitable operating site or test setup can damage the power sensor
and to connected devices. Before switching on the power sensor, observe
the information on appropriate operating conditions provided in the data
sheet. In particular, ensure the following:
●
The power sensor is dry and shows no sign of condensation.
●
The power sensor is connected as described in the following sections.
●
The ambient temperature does not exceed the range specified in the
data sheet.
●
Signal levels at the input connectors are all within the specified ranges.
●
Signal outputs are correctly connected and are not overloaded.
