Rohde & Schwarz NRP T Series, User Manual

Page: 60 / 169

Replacing an R&S NRP
‑
Zxx with an R&S NRPxxT(N)
R&S
®
NRPxxT(N)
60 User Manual 1177.6023.02 ─ 08
8 Replacing an R&S NRP
‑
Zxx with an R&S
NRPxxT(N)
The R&S NRPxxT(N) power sensors are compatible with the R&S NRP
‑
Zxx series of
power sensors.
R&S NRPxx power sensor Replaces R&S NRP
‑
Zxx power sensor
R&S NRP18T / R&S NRP18TN - USB connected R&S NRP-Z51
R&S NRP33T / R&S NRP33TN - USB connected R&S NRP-Z52
R&S NRP40T / R&S NRP40TN - USB connected R&S NRP-Z55 model .03
R&S NRP50T / R&S NRP50TN - USB connected R&S NRP-Z56
R&S NRP67T / R&S NRP67TN - USB connected R&S NRP-Z57
R&S NRP90T / R&S NRP90TN - USB connected -
R&S NRP110T R&S NRP-Z58
To use the new power sensors, it can be required to update the drivers. For computer-
based software applications (R&S
NRPV and R&S Power Viewer), install latest
R&S NRP Toolkit (V 4.20 or higher).
For using the sensors with R&S NRP2, signal generators, spectrum analyzers or other
Rohde & Schwarz instruments, install the latest firmware version.
8.1 Most Important Differences
The new and the old sensors are compatible as far as possible. However, there are
some differences:
●
The state of the sensors is indicated by an LED, see Chapter 4.4, "Status LED" ,
on page 26.
●
After connecting the R&S NRPxxT(N) sensors, the first measurement can be avail-
able after 7 seconds (R&S
NRP
‑
Zxx: 4 seconds).
8.2 Prerequisites
R&S NRP Toolkit
Install the R&S NRP Toolkit V 4.20 or higher, see Chapter 5.1, "R&S NRP Toolkit" ,
on page 29.
Prerequisites