Instrument Tour
R&S
®
NGP800
22
Getting Started 5601.5603.02 ─ 05
USB connector (16)
USB Type-B connector provides remote control operation via USB.
Ethernet connector (17)
10/100 Ethernet port for remote control operation via the local area network.
4.2
Switching On the Instrument
Before switching on the instrument, check that all the instructions in the “Basic
Safety Instruction” brochure and safety measures in previous sections are
observed.
To switch on instrument:
1. Connect the power cable to the AC power connector at the rear panel of the
R&S
NGP800 power supply.
2. Connect the power cable to the socket outlet.
3. Toggle the power rocker switch at the rear panel to turn on the instrument.
The instrument performs a system check, boots the operating system, and
starts the R&S
NGP800 power supply firmware.
It takes a few seconds for the power supply to complete the initialization before it
is ready for use. If the instrument does not turn on, verify that the power cord is
securely plugged-in and power is available at the outlet. Check if the standby
power is lit at the [Power] key on the front panel. If the standby power is lit, press
the [Power] key to initiate the start-up sequence.
To switch off instrument:
1. Press the [Power] key.
The R&S
NGP800 power supply initializes the power down sequence and
enters into standby mode. The R&S
NGP800 operates at low power.
2. Toggle the rocker switch at the rear panel to turn off the instrument completely.
3. Disconnect the AC power cable from the socket outlet.
Switching On the Instrument
