Instrument Functions
R&S
®
NGA100
41
User Manual 5601.8919.02 ─ 03
1. Press [Voltage] or [Current] key.
The previous set channel is selected.
The channel font changes to blue and all the navigation controls illuminate.
Selected [Voltage] or [Current] key and the channel key are also illuminated.
2. Press the desired channel key to switch to that channel.
Selected channel key ([Ch 1], [Ch 2]) illuminates.
3. Enter the desired voltage or current value.
4. Press the rotary knob, [Voltage]/[Current] or [Enter] key to confirm the value.
The selected channel font text changes to yellow.
Figure 6-2: Voltage and current settings in the instrument
See
on page 34 for alternative way to configure the volt-
age and current values.
See also
on the keypad for setting the fallback time.
6.2
Activating the Channel Output
Depending on the models, the outputs of the channels (Ch 1, Ch 2) can be switched on
or off by toggling the [Output] key on the front panel.
By default, the output is turned off when the instrument is switched on.
1. For two-channel models, press the required channel key.
Selected channel key (Ch 1, Ch 2) illuminates.
2. Press [Output] key.
The R&S NGA100 outputs the set voltage on the channel.
Depending on the operating mode, the font text in the channel display area shows
green in CV mode and red in CC mode.
See
Chapter 5.5, "Operation Modes"
Multiple outputs can be turned on or off at the same time.
Activating the Channel Output
