61
Remote Control
61
Remote Control
Now that you have successfully installed the NI-VISA
drivers, you can switch your HMC804x power supply to
the USB-TMC interface. Select the SETUP menu of your
R&S®HMC804x, and choose INTERFACE.
Use the soft key to select "USB". The following message
will be displayed.
The main view will now display "TMC" as selected inter-
face type.
Fig. 10.7: Setup menu
Fig. 10.8: Interface menu
Fig. 10.6: NI-VISA feature installation locally
Finally, use a USB interface cable (type A – B) to connect
the power supply with your Windows PC. On the first use,
the operating system issues the following message:
"Found New Hardware". Once the installation has been
successfully completed, the following message will be
displayed: "Device Setup" - "USB Test and Measurement
Device (IVI), ready to use“.
Once you open the Windows Device Manager, the follow-
ing entry will be displayed: "USB Test and Measurement
Devices --> USB Test and Measurement Device (IVI)"
10.3 Ethernet
For the direct connection with a host (PC) or indirect
connection over a SWITCH, a doubly protected network
cable (e.g. CAT.5, CAT.5e, CAT.5+, CAT.6 or CAT.7) is
required, equipped with an Ethernet plug type the RJ-45 at
each end. Either an uncrossed or a crossed network cable
(cross over cable) can be used.
Fig. 10.10: Instrument driver installation
Fig. 10.11: Device manager
Fig. 10.9: TMC display
Summary of Contents for HMC804
Page 35: ...35 Anhang 35 Anhang ...
