Rohde & Schwarz FSW13, User Manual

Page: 860 / 1150

Remote Commands
R&S
®
FSW
860 User Manual 1173.9411.02 ─ 19
Parameters:
<OutputType> DEVice
Sends a trigger signal when the R&S FSW has triggered inter-
nally.
TARMed
Sends a trigger signal when the trigger is armed and ready for
an external trigger event.
UDEFined
Sends a user defined trigger signal. For more information see
OUTPut:
​
TRIGger<port>:
​
LEVel
​
.
*RST: DEVice
Manual operation: See "Output Type" on page 383
OUTPut:TRIGger<port>:PULSe:IMMediate
This command generates a pulse at the trigger output.
Suffix:
<port>
.
Selects the trigger port to which the output is sent.
2 = trigger port 2 (front)
3 = trigger port 3 (rear)
Usage: Event
Manual operation: See "Send Trigger" on page 384
OUTPut:TRIGger<port>:PULSe:LENGth <Length>
This command defines the length of the pulse generated at the trigger output.
Suffix:
<port>
.
Selects the trigger port to which the output is sent.
2 = trigger port 2 (front)
3 = trigger port 3 (rear)
Parameters:
<Length> Pulse length in seconds.
Manual operation: See "Pulse Length" on page 384
11.7.5 Adjusting Settings Automatically
The commands required to adjust settings automatically in a remote environment are
described here. The tasks for manual operation are described in
chapter 6.7, "Adjust-
ing Settings Automatically" , on page 437.
Setting Basic Measurement Parameters