Measurements
R&S
®
FSW
300
User Manual 1173.9411.02 ─ 19
Marker Type
Toggles the marker type.
The type for marker 1 is always "Normal", the type for delta marker 1 is always "Delta".
These types cannot be changed.
Note:
If normal marker 1 is the active marker, switching the "Mkr Type" activates an
additional delta marker 1. For any other marker, switching the marker type does not
activate an additional marker, it only switches the type of the selected marker.
"Normal"
A normal marker indicates the absolute value at the defined position
in the diagram.
"Delta"
A delta marker defines the value of the marker relative to the speci-
fied reference marker (marker 1 by default).
Remote command:
Reference Marker
Defines a marker as the reference marker which is used to determine relative analysis
results (delta marker values).
If a fixed reference point is configured (see
on page 497), the reference point ("FXD") can also be selected instead of another
marker.
Remote command:
Linking to Another Marker
Links the current marker to the marker selected from the list of active markers. If the x-
axis value of the inital marker is changed, the linked marker follows on the same x-
position. Linking is off by default.
Using this function you can set two markers on different traces to measure the differ-
ence (e.g. between a max hold trace and a min hold trace or between a measurement
and a reference trace).
Remote command:
Assigning the Marker to a Trace
The "Trace" setting assigns the selected marker to an active trace. The trace deter-
mines which value the marker shows at the marker position. If the marker was previ-
ously assigned to a different trace, the marker remains on the previous frequency or
time, but indicates the value of the new trace.
The marker can also be assigned to the currently active trace using the "Marker to
Trace" softkey in the "Marker" menu.
Electromagnetic Interference (EMI) Measurement (R&S
FSW-K54)
