Rohde & Schwarz FSW13, User Manual

Page: 104 / 1150

Applications and Operating Modes
R&S
®
FSW
104 User Manual 1173.9411.02 ─ 19
4.4 Starting an Application
The default application in Signal and Spectrum Analyzer mode is a Spectrum measure-
ment.
The application can be selected in the "Mode" dialog box which is displayed when you
press the MODE key.
To select an application, select the corresponding button.
The measurement channels are labeled with their default name. If that name already
exists, a sequential number is added. In remote control, the name of the measurement
channel can be changed. For details and an overview of default names see
table 11-1 .
Switching between applications
When you switch to a new application, a set of parameters is passed on from the cur-
rent application to the new one:
●
center frequency and frequency offset
●
reference level and reference level offset
●
attenuation
After initial setup, the parameters for the measurement channel are stored upon exiting
and restored upon re-entering the channel. Thus, you can switch between applications
quickly and easily.
To deactivate a channel, simply close the corresponding tab.
The remote commands required to perform these tasks are described in chapter 11.4,
"Selecting the Operating Mode and Application" , on page 682.
New Channel ...............................................................................................................105
Replace Current Channel ............................................................................................105
Duplicate Current Channel ..........................................................................................105
Starting an Application