Rohde & Schwarz FSQ series, Quick Start Manual

Page: 179 / 229

Quick Start Guide 1313.9652.62 - 02 6.31
R&S FSQ LAN Interface
Manual Operation of the R&S FSQ with XP Remote Desktop
6.7.4 Connection Setup with the R&S FSQ
After you configure the Remote Desktop Client, you need to set up the connection to the
R&S FSQ.
➢
Click the General tab. You can now enter the connection information.
➢
Enter the IP address of the R&S FSQ in the Computer field.
➢
You can save the connection information for later use by clicking the Save As... button. You
can use the Open... button to load an existing connection configuration.
➢
Press the Connect button.
The connection will be set up.
➢
If the entry Disk Drives is enabled on the Local Resources tab, a warning will appear
indicating that the drives are enabled for access from the R&S FSQ:
➢
Confirm the warning with OK .
Connection setup will be resumed.