Rohde & Schwarz FPL1000 Series, User Manual

Page: 713 / 899

Remote Commands
R&S
®
FPL1000
713 User Manual 1178.3370.02 ─ 03
If you change the horizontal position of marker <m2>, marker <m1> changes its hori-
zontal position to the same value.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<State> ON | OFF | 1 | 0
*RST:
0
Example: CALC:MARK4:LINK:TO:MARK2 ON
Links marker 4 to marker 2.
Manual operation: See " Linking to Another Marker " on page 427
CALCulate<n>:MARKer<m>[:STATe] <State>
This command turns markers on and off. If the corresponding marker number is cur-
rently active as a delta marker, it is turned into a normal marker.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<State> ON | OFF | 1 | 0
*RST:
0
Example: CALC:MARK3 ON
Switches on marker 3.
Manual operation: See " Marker State " on page 425
See " Marker Type " on page 426
See " Select Marker " on page 427
CALCulate<n>:MARKer<m>:TRACe <Trace>
This command selects the trace the marker is positioned on.
Note that the corresponding trace must have a trace mode other than "Blank".
If necessary, the command activates the marker first.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<Trace> 1 to 6
Trace number the marker is assigned to.
Setting Basic Spectrum RF Measurement Parameters