Rohde & Schwarz FPL1000 Series, User Manual

Page: 583 / 899

Remote Commands
R&S
®
FPL1000
583 User Manual 1178.3370.02 ─ 03
<sb> 1 | 2 | 3
Parameters:
<NoPowerClasses> 1 to 4
*RST: 1
Example: CALC:LIM:ESP:PCL:COUN 2
Two power classes can be defined.
Manual operation: See " Adding or Removing a Power Class " on page 311
CALCulate<n>:LIMit<k>:ESPectrum<sb>:PCLass<PClass>[:EXCLusive] <State>
This command selects the power class used by the measurement if
CALCulate<n>:
LIMit<k>:ESPectrum<sb>:MODE
is set to manual.
Note that:
●
You can only use power classes for which limits are defined.
Suffix:
<n>, <k>
.
irrelevant
<sb> 1 | 2 | 3
<PClass> 1...4
power class
Parameters:
<State> ON | OFF | 1 | 0
*RST:
0
Example: CALC:LIM:ESP:PCL1 ON
Activates the first defined power class.
Manual operation: See " Used Power Classes: " on page 310
CALCulate<n>:LIMit<k>:ESPectrum<sb>:PCLass<PClass>:LIMit[:STATe] <State>
This command selects the limit check mode for each power class.
Suffix:
<n>, <k>
.
irrelevant
<sb> 1 | 2 | 3
<PClass> 1...4
power class
Configuring and Performing Measurements