Remote Control Commands
R&S
®
EX-IQ-BOX
267
User Manual 1409.5570.32 ─ 05
[:SOURce]:BBIN:EXTernal:CLOCk:PHASe
<Phase>
[:SOURce<hw>]:IQ:OUTPut:EXTernal:CLOCk:PHASe
<Phase>
SOURce:TRANsmitter:CLOCk:PHASe
<Phase>
SOURce:RECeiver:CLOCk:PHASe
<Phase>
[:SOURce<hw>]:EBOX:USER:CLOCk:PHASe
<Phase>
Sets a phase shift of the active clock edge in 90° steps related to the data bits.
Note: SCPI notation varies
The SCPI notation differs between the commands of R&S generators, R&S
DigIConf and
the R&S analyzers, as described below.
Parameters:
<Phase>
0 | 90 | 180 | 270, or P0 | P90 | P180 | P270, respectively
*RST:
0
0 | 90 | 180 | 270
Enter the value for the phase shift of the clock signal, if you
remotely control R&S
DigIConf or R&S signal generators.
P0 | P90 | P180 |
P270
Enter the value with
P
, when you remotely control R&S signal
analyzers.
Example:
SOUR1:EBOX:USER:CLOC:PHAS 180
define a phase shift of 180 degree for the clock edge.
Manual operation:
See
[:SOURce]:BBIN:EXTernal:CLOCk:POLarity
<Polarity>
[:SOURce<hw>]:IQ:OUTPut:EXTernal:CLOCk:POLarity
<Polarity>
SOURce:TRANsmitter:CLOCk:POLarity
<Polarity>
SOURce:RECeiver:CLOCk:POLarity
<Polarity>
[:SOURce<hw>]:EBOX:USER:CLOCk:POLarity
<Polarity>
Sets the clock polarity of the active clock edge for triggering the signal transmission.
Note:
Setting the clock polarity negative is equivalent to setting the clock phase to 180°.
Parameters:
<Polarity>
POSitive | NEGative
Positive
Activates the rising edge of the clock signal.
Negative
Activates the falling edge of the clock signal.
*RST:
POSitive
Example:
SOUR1:EBOX:USER:CLOC:POL NEG
sets negative polarity.
[:SOURce]:BBIN:EXTernal:CLOCk:RATE
<Rate>
[:SOURce<hw>]:IQ:OUTPut:EXTernal:CLOCk:RATE
<Rate>
SOURce:TRANsmitter:CLOCk:RATE
<Rate>
User Defined - Remote Control Commands
Summary of Contents for EX-IQ-BOX
Page 147: ...Protocol Settings R S EX IQ BOX 132 User Manual 1409 5570 32 05 CPRI...
Page 391: ......
