Remote Control Commands
R&S
®
EX-IQ-BOX
248
User Manual 1409.5570.32 ─ 05
Parameters:
<point>
UI | U2V5 | AVTT | AVCC_PLL | AVCC_MGT | U1V8 | U24V |
GND | VIN | COM3V3 | AUX2V5 | DIV3V3 | CORE1V0 | VCO |
GND1 | PPC_VCC_INT | PPC_TEMP | PPC_VCC_AUX
Example:
DIAG:EBOX:POIN UI
:DIAGnostic:EBOX:POINt:VALue?
Queries the voltage value at the selected diagnostic point of the R&S
EX-IQ-BOX.
Return values:
<val>
string
Example:
DIAG:EBOX:POIN:VAL?
query the voltage value at the diagnostic point.
Usage:
Query only
:DIAGnostic:EBOX:SELect
<Select>
Select a currently connected R&S
EX-IQ-BOX in the
chapter 6.1.6.1, "EX-IQ-BOX Device
, on page 65 dialog by means of its serial number. This function is protected
and used for service purposes.
Parameters:
<Select>
float
Example:
DIAG:EBOX:SEL 100112
select the connected R&S
EX-IQ-BOX with serial number '10112'.
9.2.3 EBOX Subsystem
The
EBOX
subsystem describes all remote-control commands regarding the configuration
of the R&S
EX-IQ-BOX. Configuration parameters are set via the configuration software
R&S
DigIConf.
R&S
DigIConf may handle up to four R&S
EX-IQ-BOX devices simultaneously. There-
fore, all commands regarding to the R&S
EX-IQ-BOX start with
[:SOURce<hw>:]
in
order to select a device.
The numeric suffix
<hw>
to
SOURce
distinguishes the selected R&S
EX-IQ-BOX
[:SOURce<[1]|2|3|4>:]....
●
SOURce[1] = R&S
EX-IQ-BOX 1
If only one R&S
EX-IQ-BOX is connected the keyword
SOURce
is optional and can
be omitted.
●
SOURce2 = R&S
EX-IQ-BOX 2 (up to four are possible simultaneously)
If you work with more devices, the keyword is mandatory, i.e. the command must
contain the keyword with suffix.
R&S EX-IQ-BOX - Remote Control Commands
Summary of Contents for EX-IQ-BOX
Page 147: ...Protocol Settings R S EX IQ BOX 132 User Manual 1409 5570 32 05 CPRI...
Page 391: ......
