Common Instrument Settings
R&S
®
EVSG1000
179
User Manual 1178.6227.02 ─ 04
TCP/IP DHCP
If the network supports dynamic TCP/IP configuration using the Dynamic Host Configu-
ration Protocol (DHCP), all address information can be assigned automatically. In this
case, the TCP/IP parameters are not editable. The currently used settings are indica-
ted as
If the network does not support DHCP, the addresses must be set manually.
By default, the instrument is configured to use dynamic TCP/IP configuration and
obtain all address information automatically. This means that it is safe to establish a
physical connection to the LAN without any previous instrument configuration.
To toggle this setting via the remote keyboard, press the [Tab] key.
TCP/IP Address
Unique address of the instrument in the network. The currently assigned IP address
and submask are indicated next to the setting.
The IP address consists of four number blocks separated by dots. Each block contains
values between 0 and 255.
To change the IP address via the remote keyboard, press the [INS] key and enter the
new address.
Example:
172.17.40.139
TCP/IP Netmask
The subnet mask consists of four number blocks separated by dots. Each block con-
tains values between 0 and 255.
Example:
255.255.255.0
TCP/IP Gateway
The gateway consists of four number blocks separated by dots. Each block contains
values between 0 and 255.
Example:
192.168.1.1
This setting is only required if the R&S
EVSG1000 is installed in a network and the
instrument needs to communicate with other connected devices. For simple 1:1 con-
nections between the instrument and control PC, the setting is irrelevant.
Hostname
Unique instrument name in the network, as an alternative to the unique IP address.
Each instrument is delivered with an assigned host name (
EVSx1000
), but this name
can be changed.
Use the keypad to enter the name, see
.
Remote command:
Network (Remote) Settings
