Rohde & Schwarz EVSG-B1, User Manual

Page: 52 / 418

Configuring the Input Signal and Measurement Mode
R&S
®
EVSG1000
52 User Manual 1178.6227.02 ─ 06
3.2 Receiver Board
If a second receiver board is installed (requires the R&S EVSG-B1 option), each
receiver board can be configured to perform different measurement tasks.
To select the receiver board to configure
1. Press the [Mode] key on the front panel.
2. Select the "RX Unit 1" or "RX Unit 2" softkey.
3. Press [Enter] or the rotary knob to confirm the selection.
To select the receiver board via VNC
1. Press the [m] key on the remote keyboard.
2. Press the [PAGE UP] or [PAGE DOWN] keys to toggle between the "RX Unit 1"
and "RX Unit 2".
3. Press [Enter] to confirm the selection.
Remote command:
CH
on page 248
3.3 Measurement Mode
The measurement mode determines the type of signal for which the measurement is
performed (see
Chapter 2, "Measurements and Results" , on page 48).
To select a measurement mode
1. Press the [Mode] key on the front panel.
2. Select the required measurement mode using the rotary knob or arrow keys.
3. Press [Enter] or the rotary knob to confirm the selection.
To select a measurement mode via VNC
1. Press the [m] key on the remote keyboard.
2. Select the required measurement mode using the arrow keys.
3. Press [Enter] to confirm the selection.
Remote commands:
MODE_LOC
on page 273
MODE_GP
on page 273
MODE_MB
on page 306
Measurement Mode