Rohde & Schwarz ESRP Series, User Manual

Page: 665 / 1094

Remote Control
R&S
®
ESRP
662 User Manual 1175.7445.02 ─ 08
CALCulate<n>:MARKer<m>:MINimum:LEFT
This command positions a marker to the next higher trace minimum on the left of the
current value (i.e. in descending X direction).
If no next higher minimum value is found on the trace (level spacing to adjacent values
< peak excursion), an execution error (error code: -200) is produced.
Suffix:
<n>
.
Selects the measurement window.
<m> Selects the marker.
Example: CALC:MARK2:MIN
Positions marker 2 to the minimum value of the trace.
CALC:MARK2:MIN:LEFT
Positions marker 2 to the next higher minimum value to the left
of the current value.
Usage: Event
Manual operation: See "Next Mode" on page 181
CALCulate<n>:MARKer<m>:MINimum:NEXT
This command positions ae marker to the next higher trace minimum.
If no next higher minimum value is found on the trace (level spacing to adjacent values
< peak excursion), an execution error (error code: -200) is produced.
Suffix:
<n>
.
Selects the measurement window.
<m> Selects the marker.
Example: CALC:MARK2:MIN
Positions marker 2 to the minimum value of the trace.
CALC:MARK2:MIN:NEXT
Positions marker 2 to the next higher maximum value.
Usage: Event
Manual operation: See "Next Min" on page 181
See "Next Mode" on page 181
CALCulate<n>:MARKer<m>:MINimum[:PEAK]
This command positions the marker on the current trace minimum.
The corresponding marker is activated first or switched to marker mode, if necessary.
If no minimum value is found on the trace (level spacing to adjacent values < peak
excursion), an execution error (error code: -200) is produced.
Suffix:
<n>
.
Selects the measurement window.
Remote Commands in Receiver Mode