Rohde & Schwarz DVS SpycerBox Flex, Hardware Manual, Page: 32 / 76

2-14
SpycerBox Ultra/Flex Hardware Guide
2.3.4 Power Supply
The redundant power supply provides the system with power. It con-
sists of several independent power supply units: Even if one fails the
others will still offer enough power to keep the system working.
The following provides an overview of one of the power supply units:
Figure 2-14: Overview of power supply unit
7 VGA DB-15 connector (female) to connect a
monitor; normally with an extra graphics
card installed, this connector will not be op-
erational; however, it can be used in combi-
nation with IPMI/KVM for system
management; if you want to use this port,
please contact DVS directly in case of setup
questions
8, 9 USB ports These USB connectors (universal serial bus)
offer you the possibility to connect other
devices to your system
10 LAN (1000 Mb) Gigabit Ethernet (1000 Base-T) connection
ports to connect the system to a network
11 back surround Connector for rear surround speakers
12 side surround Connector for middle surround speakers
13 front Connector to output audio signals (line out),
e.g. for front speakers or headphones
14 mike Connector to input low-level audio signals
The system can be operated with one power supply unit out
of order. However, if another one fails, a continued operation
of the system cannot be guaranteed. Therefore, it is recom-
mended to change a failed power supply unit immediately
(see section “Power Supply Maintenance” on page 5-14).
No. Item Explanation
latch power cable socket LED handle