Preparing for Use
R&S
®
CMW500
19
User Manual 1173.9463.02 ─ 02
2.1.7.2
LAN Connector
8-pin connector RJ-45 used to connect the R&S CMW500 to a Local Area Network (LAN).
Refer to
. It supports up to 100 Mbit/s. A second LAN con-
nector labeled LAN REMOTE is available on the rear panel of the instrument.
2.1.7.3
SENSOR Connector
Lemosa 6-pin socket for NRP-Z27/-Z28 power sensors. An external power sensor can
be used to monitor the power of an external signal or calibrate an RF source
The SENSOR connector controls the power sensor but also provides the power supply
and trigger signals.
2.1.7.4
USB Connectors
Single Universal Serial Bus connectors of type A (master USB), used to connect e.g. a
keyboard, mouse or other pointing devices, a printer or an external storage device (USB
stick, CD-ROM drive etc.). All front panel USB connectors comply with standard USB 2.0;
refer to the data sheet.
USB Connection
The length of passive connecting USB cables should not exceed 1 m. The maximum
current per USB port is 500 mA.
2.1.7.5
AF Connectors
For future extensions.
2.2 Rear Panel Tour
This section gives an overview of the rear panel controls and connectors of the R&S
CMW500.
The rear connectors and interfaces are described in detail in the Annex of the operating
manual and the help system.
Rear Panel Tour
