Rohde & Schwarz CMW-KM645, User Manual

Page: 39 / 65

Command Reference
R&S
®
CMW-KM645
39 User Manual 1173.9740.02 ─ 04
Parameters:
<ExpNomPwr> The range of the expected nominal power can be calculated as
follows:
Range (Expected Nominal Power) = Range (Input Power) +
External Attenuation - User Margin
Range: –55 dBm to +55 dBm for the input power at RF 1
COM and RF 2 COM (please notice also the range
quoted in the data sheet).
*RST: 0 dBm
Example: See Specifying General Measurement Settings
Firmware/Software: V1.0.15.20
Manual operation: See "Expected Nominal Power" on page 21
CONFigure:FMSTereo:MEAS<i>:RFSettings:UMARgin <UserMargin>
Sets the margin that the R&S CMW adds to the expected nominal power in order to
determine its reference power. The reference power minus the external input attenua-
tion must be within the power range of the selected input connector; refer to the data
sheet.
Parameters:
<UserMargin> Range: 0 dB to (55 dB + External Attenuation - Expected
Nominal Power)
*RST: 0 dB
Example: See Specifying General Measurement Settings
Firmware/Software: V1.0.15.20
Manual operation: See "User Margin" on page 21
CONFigure:FMSTereo:MEAS<i>:RFSettings:MLOFfset <MLOffset>
Varies the input level of the mixer in the analyzer path.
Parameters:
<MLOffset> Range: -10 dB to 10 dB
*RST: 8 dB
Default unit: dB
Example: See Specifying General Measurement Settings
Firmware/Software: V3.2.10
Manual operation: See "Mixer Level Offset" on page 21
CONFigure:FMSTereo:MEAS<i>:RFSettings:FOFFset <FreqOffset>
Specifies a positive or negative frequency offset to be added to the carrier center fre-
quency (
CONFigure:FMSTereo:MEAS<i>:RFSettings:FREQuency
).
Signal Routing and Analyzer Settings
深圳德标仪器
135-1095-0799