General Description
R&S
®
CMW-B400B/-B405A
23
User Manual 1176.8116.02 ─ 04
Hotkey
Description
"Ref. Marker"
Enable or disable the reference marker and select the marker position. If sev-
eral traces can be displayed, a trace can also be selected.
"Marker 1 /2"
Enable or disable marker 1 or 2 and define the marker position (absolute or rel-
ative to the reference marker).
Depending on the trace mode, a trace can also be selected.
"Select Trace Mode"
Define whether marker 1 and 2 are set to the same trace as the reference
marker (collective) or to selectable individual traces.
"Marker for Result"
Enable a marker and define the marker position.
See also: "Markers" in the R&S
CMW user manual, chapter "System Overview"
3.4.6 Common View Elements
This section describes elements that are displayed for all signal types.
Statistical results
Result tables provide columns with a statistical evaluation of the results. Some result
diagrams provide a statistical evaluation via individual traces. The statistical values are
calculated as follows:
●
Current (Cur):
Value of the result obtained in the last measurement interval.
●
Average (Avg):
Average of all "Current" values referenced to the last statistics
cycle.
●
Extreme (Ext), Minimum (Min), Maximum (Max):
Largest or smallest "Current"
value that the R&S
CMW obtained since the start of the measurement.
●
Standard (Std):
Standard deviation of all "Current" values since the start of the
measurement.
Statistic count
Progress bar for the measurement. During the first single shot after the start of the
measurement, the bar shows the number of elapsed measurement intervals relative to
the "Statistic Count". A filled progress bar indicates that the first shot is complete and
the statistical depth has been reached.
Measurement Results
深圳德标仪器
135-1095-0799
