Maintenance
49
User Manual (Hardware) | 2904.4460.02 - 04
SSD Disk Maintenance
CLIPSTER
4.
Pull the tray lever outward completely and remove the disk carrier out of
the system.
Replacing the SSD Disk in the Carrier
Perform the following steps:
1.
Unscrew the screws that fix the SSD disk to the disk carrier.
2.
Exchange the defective disk with a new one and assemble it in the disk
carrier with the screws.
Reassembling the SSD Disk
After replacing the SSD disk, the disk carrier with the new disk has to be
reassembled in the system.
Perform the following steps:
1.
Slide the disk carrier back into its shaft at the disk array.
2.
Push the disk carrier completely back into the shaft. Move it until you feel
the resistance of the SSD disk interface inside the system and until the
lever retracts.
3.
Close the lever until it snaps back in place which as a result will slide the
carrier completely back in.
System Damage
Significant environmental changes, for example, altitude,
voltage, temperature, shock, vibration, etc., can damage a
SSD disk.
Handle SSD disks with great care.
It is best to use the same brand and type of SSD disk again. Otherwise a loss
of performance might occur.
