Product Description
23
User Manual (Hardware) | 2904.4460.02 - 04
Overview of the Rear
CLIPSTER
Main Connector Panel
Peripheral equipment can be connected to the CLIPSTER workstation using
the interfaces located on the main connector panel.
Main connector panel
Item
Description
LTC In
XLR connector (female) for an input of longitudinal time-
code
LTC Out
XLR connector (male) for an output of longitudinal time-
code
Analog
Audio
6.3 mm (¼") unbalanced analog stereo headphone jack
to monitor the audio of CLIPSTER.
Digital Audio Ch. 1-8
DB-25 connector (female) for a balanced audio signal in-
and output of the digital audio channels 1 to 8
(AES/EBU).
Digital Audio Ch. 9-16
DB-25 connector (female) for a balanced audio signal in-
and output of the digital audio channels 9 to 16
(AES/EBU).
RJ-45 Top
RMT-1: Serial interface for input / output of control
signals using the RS-422 protocol, see "RMT In and RMT
Out (RJ-45)" (page 68).
RJ-45 Bottom
RMT-2: Serial interface for input / output of control
signals using the RS-422 protocol, see "RMT In and RMT
Out (RJ-45)" (page 68).
HD-SDI In/Out
BNC connectors for input/output of digital HD video
signals, see also "Digital Video I/Os" below.
REF In
BNC connector for a synchronization of video signals, i.e.
the reference input; input of horizontal or composite sync
depending on software settings
SDI Downconvert
BNC connector for down-scaled SDI signal from UHD/4K
to 1080p/2K. The frame rate (up to 60 Hz) is not affected.
