Remote Commands
R&S
®
Cable Rider ZPH
249
User Manual 1321.0950.02 ─ 03
STATus:OPERation:NTRansition
<DecimalValue>
This command controls the Negative TRansition part of the OPERation register.
Setting a bit causes a 1 to 0 transition in the corresponding bit of the associated regis-
ter. The transition also writes a 1 into the associated bit of the corresponding EVENt
register.
Parameters:
<DecimalValue>
Range:
0 to 65535
STATus:OPERation:PTRansition
<DecimalValue>
This command controls the Positive TRansition part of the OPERation register.
Setting a bit causes a 0 to 1 transition in the corresponding bit of the associated regis-
ter. The transition also writes a 1 into the associated bit of the corresponding EVENt
register.
Parameters:
<DecimalValue>
Range:
0 to 65535
STATus:QUEStionable[:EVENt]?
This command reads out the EVENt section of the QUEStionable register.
The command at the same time deletes the contents of the EVENt section.
Usage:
Query only
STATus:QUEStionable:FREQuency[:EVENt]?
This command reads out the EVENt section of the QUEStionable register.
The command at the same time deletes the contents of the EVENt section.
Usage:
Query only
STATus:QUEStionable:LIMit[:EVENt]?
This command reads out the EVENt section of the QUEStionable register.
The command at the same time deletes the contents of the EVENt section.
Usage:
Query only
STATus:QUEStionable:POWer[:EVENt]?
This command reads out the EVENt section of the QUEStionable register.
The command at the same time deletes the contents of the EVENt section.
Usage:
Query only
Remote Control - Commands
