Rohde & Schwarz 6144.7800.02, Operating Manual

Page: 52 / 189

Configuring with the R&S ZS 4200 R&S EU4200C
3.9 6174.8456.02-01
3.3 Configuring with the R&S ZS 4200
Configuri ng\\ Confi guring "Nam e".doc
Introduction
The receiver is equipped with LAN and USB interfaces to allow
communication with the Service and Maintenance Tool R&S ZS 4200.
The following activities can be carried out:
 Software download
 Preset setup
 Configuration
 Inventory list
 Read/Clear event log
 Parameter adjustment
 Cloning of configuration parameters
 Operational parameters setting
Note:
For configuring with the R&S ZS 4200, see the Service and
Maintenance Tool R&S ZS 4200 software manual.
3.3.1 Factory Default Settings
Switching on
for the first time
The radio is preconfigured with the factory default settings. These settings
will be activated the first time the radio is switched on.
Switching on
in general
All radio parameters are stored in the non-volatile memory. The settings
active at the time of a power failure are restored when the radio is switched
back on.
Changing the radio
parameters
The radio is preconfigured with the factory default settings. These settings
can be changed via service PC with the Service and Maintenance Tool
R&S ZS 4200.
Properties
The properties of the parameters can have the following status:
 A – Adjustment parameter (updated immediately after a change)
 C – Cloning parameter
 O – Operating parameter (updated immediately after a change while
radio is in Local Mode)
For more details please refer to the Service and Maintenance Tool
R&S ZS 4200 software manual.
Default setting \Default sett ing " Radio ".doc
Parameters Value range Default value Properties
RX Audio Level −
30 to +10 dBm
0 dBm A/C
S/N Squelch Threshold 6 to 20 dB 10 dB A/C
RSSI Squelch Threshold 1 to 50 µV 5 µV A/C
Carrier Override Disabled/Enabled Enabled C
S/N RSSI Logical Operation AND/OR OR C
RX Audio AGC Disabled/Enabled Disabled C
ACARS Data Mode Disabled (Voice)/Enabled
(ACARS)
Disabled (Voice) C