Software and Firmware Update
R&S
®
EB510
59
Getting Started 4091.7338.02 ─ 01
4.5
Changing the IP Address
4.5.1
Using Update32 Tool
The IP address of the R&S
EB510 can be changed using the "Update32" tool. By
default, the R&S
EB510 is shipped with DHCP enabled.
Refer to "Retrieve Update32" under
chapter 4.3, "Receiver Firmware Update for
EB510 without front control panel"
, on page 48 to read the steps for retrieving and
running the "Update32" tool.
Starting the procedure
Run
Update32
and allow access if there are security warnings. If a configuration
is not loaded previously, refer to "Selecting the configuration file" under
"Receiver Firmware Update for EB510 without front control panel"
select an appropriate configuration file. Select "Config” -> “LAN Settings via Ether-
net" as shown below:
Selecting the target R&S
EB510
The R&S
EB510, for which you want to update the IP address, needs to be switched
on. Make sure there is a LAN connection between the R&S
EB510 and the PC. After
a short period, a new entry will be shown in the list of targets as shown in the figure
below. Select the appropriate target and press the "Start" button.
Changing the IP Address
