Rohde & Schwarz 2112.4100.02, Getting Started

Page: 47 / 79

Connecting the R&S SFE100
R&S
®
SFE100
28 Getting Started 2112.4122.62 ─ 13
6 Connecting the R&S SFE100
This chapter describes how to connect the R&S SFE100 to the power supply and
external devices.
6.1 Preventing Electromagnetic Interference
To prevent electromagnetic interference, the R&S SFE100 must be operated with all
shielding covers fitted. Only suitable and shielded signal and control cables may be
used.
RF/ASI/TRIGGER inputs and outputs
In particular cables that are connected to these inputs/outputs can cause EMC prob-
lems. Therefore these cables should have at least 80 dB to 1 GHz shielding. This is
usually achieved by means of double-shielded cables.
USB interfaces
To connect the USB interfaces, only use peripheral equipment that does not cause
limit violations. For details see
Chapter 5.1.6, "USB Interfaces" , on page 20.
HDMI interface
To connect the HDMI interface, only use peripheral equipment that does not cause
limit violations. For details on the interface see
Chapter 5.2.5, "MONITOR" ,
on page 23.
LAN interface (100 BASE-T)
To connect the LAN interface (100 BASE-T), use a suitable cable. For details see
Chapter 5.2.6, "100 BASE-T" , on page 23.
6.2 Connecting to the AC Power Supply
The R&S SFE100 can be used with different AC power voltages and adapts itself auto-
matically to it. Adjusting the R&S SFE100 to a particular AC supply voltage is therefore
not required. Refer to the data sheet for the requirements of voltage and frequency.
Connecting to the AC Power Supply