Rohde & Schwarz 1430.0105K02, User Manual

Page: 188 / 206

Remote Control
R&S
®
NRT2
188 User Manual 1178.5550.02 ─ 04
Suffix:
<Measurement>
.
1...100
Parameters:
<unit> DBM | DBUV | W
*RST:
DBM
Manual operation: See "Fwd Unit" on page 41
UNIT<Measurement>:POWer:REFLection <unit>
This command defines the matching of the load being measured as standing wave
ratio, return loss, reflection coefficient, or power ratio R/F (in percent).
NOTE : The command is only effective if the measurement function
POW:S11
or
POW:
REFL
has been activated, see SENS<n>:FUNC subsystem
Suffix:
<Measurement>
.
1...100
Parameters:
<unit> RCO | RL | SWR | RFR
RCO
Reflection coefficient (0 to 1, without unit)
RL
Return loss (in dB)
SWR
Standing wave ratio (1 to ∞, without unit)
RFR
Ratio between forward and reverse power (0% to 100%)
*RST:
SWR
Example: SENSe1:FUNC "POW:REFL"
UNIT1:POW:REFL RCO
Manual operation: See "Standing Wave Ratio (SWR)" on page 41
See "Return Loss" on page 41
See "Reflection Coefficient" on page 41
See "Reflection Ratio" on page 41
UNIT<Measurement>:POWer:RELative:STATe <state>
This command defines the indication of the forward power (FWD), reverse power
(REV) and absorbed power (F-R) in absolute units (W, dBm) or in relative display
mode (%, dB).
Suffix:
<Measurement>
.
1...100
Parameters:
<state>
UNIT