Rohde & Schwarz 1424.7805K02, User Manual

Page: 396 / 530

Remote control commands
R&S
®
NRX
396 User Manual 1178.5566.02 ─ 09
Example: MEM:STAT:MAP? "test"
Manual operation: See "Save / Recall Setup" on page 135
See "Setup Name" on page 135
MEMory:STATe:RESet
Resets the setup names to factory default, "Setup 1", "Setup 2" and so on.
Usage: Event
MEMory:TABLe:DATA?
Queries the content of the selected table.
Use
MEMory:TABLe:SELect
to select the table.
The response consists of data pairs (frequency - offset):
<frequency 1>,<offset 1>,<frequency 2>,<offset 2>,<frequency 3>,<offset 3>, ...
Frequency in Hz, offset in dB.
Example: MEM:TABL:DATA?
Query
1.02,0.00,2.03,
0.00,3.04,0.00
Response
Usage: Query only
MEMory:TABLe:DATA:POINts?
Queries the number of data pairs (frequency - offset) in the selected table.
Use
MEMory:TABLe:SELect
to select the table.
Usage: Query only
MEMory:TABLe:FREQuency <value>...
Defines the frequency values in the selected correction table. Existing data is overwrit-
ten. Take care that the number of frequency values matches the number of offset val-
ues, defined by
MEMory:TABLe:GAIN[:MAGNitude]
. If the numbers differ, excess
values are ignored.
Use
MEMory:TABLe:SELect
to select the table.
Parameters:
<value> Numeric values with a maximum of 2 digits after the decimal
point, separated by commas. Values with more than 2 decimal
places are rounded.
Default unit: Hz
Managing setups and correction tables