Rohde & Schwarz 1424.7805K02, User Manual

Page: 27 / 530

Getting started
R&S
®
NRX
27 User Manual 1178.5566.02 ─ 09
●
Chapter 13.9, "Configuring the test generator" , on page 376
●
Chapter 3.1.8.2, "Optional interface for R&S NRT-Z sensors (R&S NRX-B9)" ,
on page 22
3.2.1.3 Touchscreen
See (3) in Figure 3-3 .
The R&S NRX displays results in panes. Depending on the measurement mode, val-
ues are displayed digitally or graphically.
False triggers can occur
If an object (e.g. a human finger) that is charged with static electricity is brought near
the touch panel, false triggers can occur.
This behavior is caused by the principle of operation of a PCAP (projected capacitive)
touch panel.
Further information:
●
"Using the touchscreen" on page 33
3.2.1.4 Keys
See (4) in Figure 3-3 .
[Esc] / Local
If you press shortly:
●
Changes to the next-higher hierarchy level.
●
Escapes from the entry mode in text boxes and lists.
●
Closes dialogs without losing any entries that have been made.
●
Switches from remote control mode (all controls disabled) to manual operation.
If you press and hold:
●
Goes to the start dialog that shows an overview of the active measurements.
See
Chapter 4.1.1, "Start dialog" , on page 33.
Further information:
●
"Going back to a higher hierarchy level" on page 33
●
Chapter 4.3.2, "Returning to manual operation (LOCAL)" , on page 45
Screenshot
Creates a screenshot of the current display.
See Chapter 4.1.8, "Creating and saving screenshots" , on page 42.
Remote command:
SYSTem:HCOPy
on page 229
[1Trig] / Delete
●
Controls the measurements depending on the trigger mode:
–
For all trigger modes except "Single", starts and stops the measurement.
– For the "Single" trigger mode, enables and triggers the measurement.
Instrument tour