Rohde & Schwarz 1424.7805K02, User Manual

Page: 245 / 530

Remote control commands
R&S
®
NRX
245 User Manual 1178.5566.02 ─ 09
[SENSe<Sensor>:]POWer:REFerence <ref>
Sets the reference value for the relative power indication.
If you enter a value without unit, the unit is defined by
SENSe<Sensor>:UNIT:
POWer[:VALue]
. For further information, see Chapter 13.6.1.3, "Units" , on page 217.
Suffix:
<Sensor>
.
1 to 128
Configured sensor connected at: port A = 1, ... , port D = 4, R&S
NRX-B9 = 101, USB and LAN port = 5 to 100
Parameters:
<ref> Range: -290.0 to +110.0
*RST: +30.0
Default unit: dBm
Manual operation: See "Forward Reference Value, Reflection Reference Value"
on page 58
See
"Reference Value" on page 73
13.6.6 Continuous average measurements
There are several ways to programm the R&S NRX for measurements. See Chap-
ter 13.4, "Making measurements" , on page 188.
Further information:
●
Chapter 6.2, "Continuous average" , on page 72
13.6.6.1 Combining commands for continuous average measurements
See also Chapter 13.4, "Making measurements" , on page 188.
Parameter list for continuous average measurements
Parameter Description
<expected_value> Optional. Value that is expected for the measurement.
<resolution> Optional. Limit up to which the measurement result probably is free of
noise.
Corresponds to
[SENSe<Sensor>:]AVERage:COUNt:AUTO:
RESolution
.
<source_list> Mandatory. Primary and secondary sensor. The number for each sensor
is preceded by the character
@
. The entire expression is enclosed in
parentheses.
Example: (
@
3),(
@
2)
Sensor C is the primary sensor, and sensor B is the secondary sensor.
Measurement settings and results