Rohde & Schwarz 1424.7805K02, User Manual

Page: 235 / 530

Remote control commands
R&S
®
NRX
235 User Manual 1178.5566.02 ─ 09
The command is not fully R&S NRP2 compatible. If port 1 is assigned to measure-
ment 1 and so on, the command works. If port 1 is assigned to measurement 2, for
example, enable the R&S NRP2 emulation using
SYSTem:LANGuage "NRP2"
.
Suffix:
<Measurement>
.
1 to 8
Measurement
<Channel> 1 to 2
1 = primary sensor, 2 = secondary sensor
Parameters:
<level> Range: -290.0 to +223.01
*RST: -10.0
Default unit: dBm
Manual operation: See "Trigger Level" on page 66
TRIGger<undef>:ALL:MODE <mode>
TRIGger<Measurement>:MODE <mode>
Controls the trigger execution depending on the setting of the trigger source, see
TRIGger<Measurement>[:CHANnel<Channel>]:SOURce
.
Suffix:
<Measurement>
.
1 to 8
Measurement
Parameters:
<mode> NORMal | FREerun | SINGle | AUTO
NORMal
Continuous triggering with regular trigger events.
FREerun
Enables a continuous measurement. The power sensor exe-
cutes one measurement cycle after the other.
SINGle
Disables continuous triggering so that only one trigger event at a
time is executed.
AUTO
Automatically starts a measurement if no trigger event has
occurred after 300
ms.
*RST: AUTO
Manual operation: See "Trigger Mode" on page 66
TRIGger<Measurement>[:CHANnel<Channel>]:SENDer:PORT <port>
Effective only if the connected sensor is trigger sender, see
TRIGger<Measurement>[:CHANnel<Channel>]:SENDer[:STATe]
.
Sets the port where the trigger sender sensor outputs a digital trigger signal.
Measurement settings and results