Rohde & Schwarz 1424.7805K02, User Manual

Page: 232 / 530

Remote control commands
R&S
®
NRX
232 User Manual 1178.5566.02 ─ 09
TRIGger<undef>:ALL:DELay[:VALue] <delay>
TRIGger<Measurement>[:CHANnel<Channel>]:DELay[:VALue] <delay>
Sets the delay between the trigger event and the beginning of the actual measurement.
The command is not fully R&S NRP2 compatible. If port 1 is assigned to measure-
ment 1 and so on, the command works. If port 1 is assigned to measurement 2, for
example, enable the R&S NRP2 emulation using
SYSTem:LANGuage "NRP2"
.
Suffix:
<Measurement>
.
1 to 8
Measurement
<Channel> 1 to 2
1 = primary sensor, 2 = secondary sensor
Parameters:
<delay> Range: -5.0 to 10.0
*RST: 0.0
Default unit: s
Manual operation: See "Delay" on page 67
TRIGger<undef>:ALL:DTIMe <dropout>
TRIGger<Measurement>[:CHANnel<Channel>]:DTIMe <dropout>
If the trigger level has been underrun with internal triggering, it is sometimes useful to
wait some time (drop-out time) before retriggering. The measurement of unwanted sig-
nal components can thus be suppressed. See
Chapter 6.1.3.3, "Dropout time" ,
on page 64.
The command is not fully R&S NRP2 compatible. If port 1 is assigned to measure-
ment 1 and so on, the command works. If port 1 is assigned to measurement 2, for
example, enable the R&S NRP2 emulation using
SYSTem:LANGuage "NRP2"
.
Suffix:
<Measurement>
.
Measurement
<Channel> 1 to 2
1 = primary sensor, 2 = secondary sensor
Parameters:
<dropout> Range: 0.0 to 10.0
*RST: 0.0
Default unit: s
Manual operation: See "Dropout" on page 67
TRIGger<Measurement>[:CHANnel<Channel>]:EXTernal<Port>:IMPedance
<impedance>
Requires a power sensor with a trigger input.
Measurement settings and results