
System settings
R&S
®
NRX
139
User Manual 1178.5566.02 ─ 09
10.1.1
Network settings
Access: [System]
> "Connections"
> "Network"
Contains the settings for integrating the R&S NRX in a network. There are two meth-
ods to establish a network connection between R&S NRX and computer:
► Connect both to a common network (infrastructure network).
► Connect R&S NRX and computer only over the switch (peer-to-peer network).
In this case, the use of a static IP address is recommended.
Connection errors can affect the entire network. If your network does not support
DHCP, or if you choose to disable dynamic TCP/IP configuration, assign a valid
address information before connecting the R&S NRX to the LAN. Contact your network
administrator to obtain valid IP addresses.
After integrating the R&S NRX into a network, you can set up the following connec-
tions:
●
Remote control connection to control the R&S NRX using SCPI commands.
See
●
Remote desktop connection for remote operation or file transfer.
See
Chapter 4.2, "Remote operation"
The "Network" dialog is divided into the following tabs:
........................................................................................... 141
...............................................................................................141
.................................................................................................142
........................................................................................... 142
Connections