Instrument tour
R&S
®
NRX
26
Getting Started 1424.7070.02 ─ 09
[Esc] / Local
If you press shortly:
●
Changes to the next-higher hierarchy level.
●
Escapes from the entry mode in text boxes and lists.
●
Closes dialogs without losing any entries that have been made.
●
Switches from remote control mode (all controls disabled) to manual opera-
tion.
If you press and hold:
●
Goes to the start dialog that shows an overview of the active measurements.
Screenshot
Creates a screenshot of the current display.
[1Trig] / Delete
●
Controls the measurements depending on the trigger mode:
– For all trigger modes except "Single", starts and stops the measurement.
– For the "Single" trigger mode, enables and triggers the measurement.
Changes of the trigger state apply to all measurements.
●
Resets the auxiliary values that provide additional information about the mea-
sured values.
●
Deletes numbers or text in a field so that you can enter a new value.
Enter
●
Confirms entries in text fields, dialogs and selections in lists.
●
Shows a frame around the control in focus. You can change the focus using
the
[Freq]
Sets the carrier frequency of the applied signal. This value is used for fre-
quency-response correction of the measurement result.
Favorites
Reserved for future use.
[Preset]
Opens the "Save / Recall / Preset" dialog.
If you press [Preset] again, the preset function starts.
If you press the [Preset] key during booting, the R&S NRX starts with the factory
default state.
Front panel tour
