Putting into Operation
R&S
®
RT
‑
ZD10/20/30
20
User Manual 1410.4550.02 ─ 01
All settings of the base unit described in this section refer to the R&S RTO
oscilloscope. If any other oscilloscope is used, differences in settings and
menu navigation may be possible.
2.1.1
Connecting the Probe to the R&S RTO Oscilloscope
The R&S
RT
‑
ZD10/20/30 differential probe has been designed for use with R&S
RTO oscilloscopes.
► Connect the probe box (1) to the Rohde & Schwarz probe interface of the
base unit (2). The probe will snap in when connected properly to the port.
► To disconnect, press the release button (3) and pull the probe box away from
the front panel of the base unit.
Fig. 2-1: Connecting the probe to the R&S RTO oscilloscope
2.1.2
Identification of the Probe
When the probe is connected to the oscilloscope, the oscilloscope recognizes the
probe and reads out the probe-specific parameters. The oscilloscope settings for
attenuation and offset are automatically adjusted.
Installation
