Rohde & Schwarz 1332.4500.22, User Manual

Page: 813 / 1476

Command Reference
R&S
®
ZNA
813 User Manual 1178.6462.02 ─ 12
Parameters:
<Constant> Constant value
Range:
The range depends on the trace format. For the
default trace: -200 dB to + 200 dB.
Increment: 10E-2 dB
*RST:
0 dB
Example: See
CALCulate<Chn>:LDEViation:AUTO
on page 812
Manual operation: See "Constant" on page 357
CALCulate<Chn>:LDEViation:ELENgth <ElLength>
Defines the electrical length for the linearity deviation calculation. This command is
available if the active trace format is Phase or Unwrapped Phase, or if a mixer delay is
measured.
Suffix:
<Chn>
.
Channel number used to identify the active trace.
Parameters:
<ElLength> Electrical length
Range:
0 m to + 1000 m.
Increment: 10E-4 m
*RST:
0 m
Default unit: m
Example: See
CALCulate<Chn>:LDEViation:AUTO
on page 812
Manual operation: See "El. Length" on page 357
CALCulate<Chn>:LDEViation:MODE <Mode>
Applies /discards the correction factors or re-calculates them for each trace (Tracking).
Suffix:
<Chn>
.
Channel number used to identify the active trace.
Parameters:
<Mode> OFF | ON | TRACking
Apply the correction using the latest correction factors.
ON - Apply the correction using the latest correction factors.
OFF - Discard the correction.
TRACking - Repeat calculation for each measured trace and
apply the correction.
*RST:
0 dB/MHz
Example: See
CALCulate<Chn>:LDEViation:AUTO
on page 812
Manual operation: See "On" on page 356
SCPI Command Reference