GUI Reference
R&S
®
ZNA
624
User Manual 1178.6462.02 ─ 12
Figure 6-41: Eye Diagram Results (NRZ Modulation)
●
For PAM modulation types only a reduced set of "Basic" results is available.
Figure 6-42: Eye Diagram Results (PAM Modulations)
For a description of the result values see
Remote command:
CALCulate<Chn>:EYE:MEASurement:STATe
CALCulate<Chn>:EYE:MEASurement:DATA?
Measurements...
If the active trace is an eye diagram, the "Measurements..." button brings up a dialog
which allows to select and configure the eye measurements to be displayed (if
is enabled).
The following measurement results can be selectively enabled/disabled:
●
"Basic" – Eye Minimum, Eye Maximum, Eye Base, Eye Top, Eye Mean, Eye Ampli-
tude, Eye Height, Eye Width
For PAM signals (see
on page 627) Eye Height and Eye Width are
not available.
●
"Time" – Bit Period, Rise Time, Fall Time, Jitter Pk-Pk, Jitter RMS, Duty Cycle Dist,
Duty Cycle Pct, Crossing Percent, Opening Factor, SNR
Applic Softtool
