GUI Reference
R&S
®
ZNA
471
User Manual 1178.6462.02 ─ 12
Save/Cancel
Saves the channel calibration definitions to the current setup or discards unsaved mod-
ifications.
6.11.1.7
Guided Calibration Wizard
The "Guided Calibration" wizard lets you calibrate a set of channels using the calibra-
tion methods the firmware proposes for the related measurements.
If a calibration unit is connected, it is automatically used.
Access:
Channel – [Cal] > "Start Cal" > "Start... (Guided)"
Step 1: Channel Selection
See
Chapter 6.11.1.8, "Channel Selection for Calibration Dialog"
on page 472. The
channel selection is shown, even if the active recall set contains only one channel.
Step 2: Calibration Settings
Defines power settings that apply to all subsequent calibrations and allows you to
select some optional calibration steps.
Step 3: Ports and Calibration Types
In step 3 the "Guided Calibration" wizards repeatedly calls the
During the calibration phase, a progress bar below the active calibration wizard's dock
widget indicates the overall progress of the guided calibration.
After all required calibration steps were performed, the "Guided Calibration" wizards
asks you to connect your DUT to the VNA as you have specified in the "DUT/VNA
Connections step".
Cal Softtool
