Getting Started
R&S
®
ZNL/ZNLE
62
User Manual 1178.5966.02 ─ 07
Chapter 8.2.3, "Trace Formats"
on page 208 to learn more about the diagram
properties.
5.3.1.2
Reflection S-Parameter Measurement
In a reflection measurement, the analyzer transmits a stimulus signal to the input port
of the device under test (DUT) and measures the reflected wave. Different trace for-
mats allow you to express and display the results, depending on what you want to
learn from the data. Only one analyzer test port is required for reflection measure-
ments.
In principle, a reflection measurement involves the same steps as a transmission mea-
surement. Note the following differences:
●
The basic test setup for reflection measurements involves a single DUT and ana-
lyzer port. For instance, you can connect the input of your DUT to port 1 of the ana-
lyzer as shown below.
You can also use the basic transmission test setup, e.g. if you want to measure
reflection and transmission parameters in parallel.
Trying Out the Instrument
www.allice.de
Allice Messtechnik GmbH
