
Getting Started
R&S
®
Spectrum Rider FPH
27
User Manual 1321.1011.02 ─ 11
Risk of traffic accidents, physical injury and property damage
●
Turn off the R&S Spectrum Rider while driving or while the engine is on.
●
Operation of the R&S Spectrum Rider via the cigarette lighter socket while driving
or while the engine on is prohibited.
3.1.1.6
Battery Maintenance
The R&S Spectrum Rider comes with a lithium-ion battery. In general, these batteries
are easy to handle. When you handle the battery, follow the instruction mentioned in
the safety instructions and in the following chapters.
Handling
●
The battery has been designed for a specific application. Do not use it for any other
applications.
●
Do not connect batteries in series or parallel as it can cause serious damage.
●
Observe correct polarities during installation and charging.
●
Do not heat over 70°C. The battery contains thermal fuses that could activate and
render the battery inoperable.
●
The battery contains an electronic device for protection against deep discharge,
overcharge and short-circuiting between the terminals.
–
If you cannot discharge the battery, it may be deep discharged. Charge the bat-
tery for 0.5 hours and check again.
–
If you cannot charge the battery, it may be overcharged. Discharge the battery
and check again.
–
If the battery has been short-circuited, charge it to reset the electronics.
–
If the battery still does not work, contact the Rohde & Schwarz customer sup-
port.
●
Do not allow metallic objects to come into contact with the terminals.
●
Do not solder directly to the battery.
Storage
The battery self-discharges while not in use. When storing the battery for an extended
period of time, make sure to
●
Handle the battery carefully to avoid short circuits. Make sure that leads and termi-
nals are insulated.
●
Keep the battery in the supplied packaging before use. The temperature should not
exceed 30°C.
●
Store the battery at an initial state of charge between 15% and 50% of its capacity.
When calculating the initial state of charge, consider
–
The maximum consumption of electronic devices
Preparing for Use
www.allice.de
Allice Messtechnik GmbH