Working with the Measurement Wizard
R&S
®
Spectrum Rider FPH
116
User Manual 1321.1011.02 ─ 11
Figure 5-2: Measurement setting dialog
Table 5-1: Measurement setting parameters
Measurement parameters
Descriptions
"General"
User
Name of the person that performs the measurement.
Measurement
Definition
Name of the measurement wizard set. This field is a read-
only field that shows the measurement name as defined in
the R&S InstrumentView software package.
Number of
Steps to Per-
form
Number of individual measurements in the measurement
sequence as defined with the R&S InstrumentView soft-
ware package.
The field allows you to reduce the number of individual
measurements and perform only those measurements that
are necessary. If you reduce the number of measurements,
the R&S Spectrum Rider omits the last measurement in the
sequence.
You can edit this field only if you turned on the "Allow Vari-
able Number of Sequence Steps" in the "Wizard Set Editor"
of the R&S InstrumentView software.
Descriptions
Short description of the measurement task. This field is a
read-only field that shows the description as defined with
the R&S InstrumentView software.
"Site"
Site Name
Location of the measurement.
Comments
Comments about the measurement, e.g. the external con-
ditions during the measurement.
GPS Position
Displays the GPS information. See
Measurement specification
The measurement specification dialog box displays the measurement step sequences
and the individual performed measurement status. See
Performing and Configuring Measurements
www.allice.de
Allice Messtechnik GmbH
