Remote control commands
R&S
®
NRPxxTWG
56
User Manual 1178.8371.02 ─ 08
Parameters:
<count>
Range:
1 to 8192
*RST:
1
Example:
BUFF:SIZE 1
See
Chapter 8.2, "Performing a buffered continuous average
[SENSe<Sensor>:][POWer:][AVG:]BUFFer:STATe
<state>
Enables or disables the buffered continuous average mode. If the buffer mode is
enabled, all results generated by trigger events are collected in the sensor until the buf-
fer is filled.
You can set the size of the buffer using
.
Parameters:
<state>
ON | OFF
*RST:
OFF
Example:
BUFF:STAT OFF
[SENSe<Sensor>:][POWer:][AVG:]SMOothing:STATe
<state>
Enables or disables the smoothing filter, a steep-edge digital lowpass filter. If you can-
not adjust the aperture time exactly to the modulation period, the filter reduces result
fluctuations caused by modulation.
Parameters:
<state>
ON | OFF
*RST:
OFF
Example:
SMO:STAT OFF
7.8
Configuring basic measurement parameters
The following section describes the settings common for several measurement modes.
7.8.1
Configuring auto averaging
Describes the commands for automatic averaging in continuous average measure-
ments.
Remote commands:
..................................................................................57
[SENSe<Sensor>:]AVERage:COUNt:AUTO
........................................................................57
[SENSe<Sensor>:]AVERage:COUNt:AUTO:MTIMe
.............................................................57
Configuring basic measurement parameters
