Commissioning
R&S
®
TS-PCA3
46
User Manual 1152.3908.12 ─ 19
4.4
Connections
4.4.1
Line Inlet
The R&S TS-PCA3 requires a supply within the range of 110 VAC / 60 Hz or
230
VAC
/
50
Hz. Fuse protection for the line inlet must not exceed a rating of 16 A.
The PSU used in the R&S TS-PCA3 has
automatic voltage selection
between 100
and 240 Volt AC (see Section 9, Technical Data).
4.4.2
Connections at the Rear
Figure 4-1: Rear Connections without Option
1 = Knockouts for system and user-specific connections
2 = Analog bus connections
3 = Power connection
4 = Slots for Rear I/O modules
5 = System module
In its basic configuration, the R&S TS-PCA3 only has the power connection (3), the
analog bus connection (2) and the connector for the system module (5). All other con-
nections are system and user-specific.
System-specific connectors (e.g. D-sub) can be installed at the back of the R&S TS-
PCA3 (1). You will find more details in Section 4.5, Cabling.
Connections