Rohde & Schwarz 1145.1010.04/05/06, Operating Manual

Page: 400 / 813

Display Menu R&S
®
ZVA/ZVB/ZVT
1145.1084.12 4.238 E-6
Next Diag. Area
Selects the next diagram area as the active diagram area. This function is disabled if the current setup
contains only one diagram area. The order of the diagram areas is given by the diagram numbers
displayed in the upper right corner.
The diagram number of the active diagram area is highlighted. If one or several traces are assigned to
the next diagram area, the last active trace again becomes the active trace.
To activate any diagram area including the last active trace in this area, simply click
a point inside the new area.
Remote
control:
The numeric suffix
<Wnd>
appended to the
DISPlay:WINDow<Wnd>:...
commands selects a diagram area.
Select Diag. Area
Opens a box to select an arbitrary diagram area of the active setup as the active diagram area. This
function is disabled if the current setup contains only one diagram area. The diagram area numbers are
displayed in the upper right corner.
The diagram number of the active diagram area is highlighted. If one or several traces are assigned to
the previous diagram area, the last active trace again becomes the active trace.
To activate any diagram area including the last active trace in this area, simply click
a point inside the new area.
Remote
control:
The numeric suffix
<Wnd>
appended to the
DISPlay:WINDow<Wnd>:...
commands selects a diagram area.
Add Diag. Area + Trace
Creates a new diagram area and a new trace, which is displayed in the new diagram area. The trace is
created with the channel settings of the previous active trace but with default trace settings.
The new diagram area is numbered <n>, where <n> is the largest of all existing diagram area numbers
plus one.
Remote control:
DISPlay:WINDow<Wnd>:STATe ON