Rohde & Schwarz 1145.1010.04/05/06, Operating Manual

Page: 356 / 813

Channel Menu R&S
®
ZVA/ZVB/ZVT
1145.1084.12 4.194 E-6
You can monitor the channel activity using the
OUTPut<Ch>:UPORt[:VALue]
<numeric_value>
command and the output signals at pins 8 to 11 of the USER CONTROL
connector.
Next Channel
Selects the next channel in a list of defined channels as the active channel. This function is disabled if
the current setup contains only one channel.
If one or several traces are assigned to the next channel, one of these traces becomes the active trace.
The order of all channels belonging to a setup is given by the channels' creation time. By default, the
channels are named Ch1, Ch2, ... so that Ch<n> follows Ch<n – 1>. This order is always maintained,
even if channels are renamed, invisible (because no traces are assigned to them) or distributed over
several diagram areas.
Remote
control:
The numeric suffix
<Ch>
appended to the first-level mnemonic of a command selects
a channel as active channel.
Select Channel
•
Opens a box to select an arbitrary trace of the active setup as the active trace. This function is
disabled if the current setup contains only one channel.
If one or several traces are assigned to the selected channel, one of these traces becomes the active
trace.
The order of all channels belonging to a setup is given by the channels' creation time. By default, the
channels are named Ch1, Ch2, ... so that Ch<n – 1> precedes Ch<n>. This order is always maintained,
even if channels are renamed, invisible (because no traces are assigned to them) or distributed over
several diagram areas.
Remote
control:
The numeric suffix
<Ch>
appended to the first-level mnemonic of a command selects
a channel as active channel.