Rohde & Schwarz 1065.6000.20, Operating Manual

Page: 264 / 438

FSE SENSe Subsystem
1065.6016.12 6.207 E-16
SENSe:SWEep Subsystem
This subsystem controls the sweep parameters.
COMMAND PARAMETERS UNIT COMMENT
[SENSe<1|2>]
:SWEep
:TIME
:AUTO
:COUNt
:EGATe
:LEVel
:TYPE
:POLarity
:HOLDoff
:LENGth
:SOURce
:GAP
:PRETrigger
:TRGTogap
:LENGth
:SPACing
<numeric_value>
<Boolean>
<numeric_value>
<Boolean>
<numeric_value>
LEVel | EDGE
POSitive|NEGative
<numeric_value>
<numeric_value>
EXTernal | RFPower
<Boolean>
<numeric_value>
<numeric_value>
<numeric_value>
LINear | LOGarithmic
S
--
--
--
V
--
--
S
S
--
--
S
S
S
:[SENSe<1|2>:]SWEep:TIME <numeric_value>
This command defines the duration of the sweep.
The allowed value range depends on the selected domain and, for frequency domain, on the set
resolution bandwith (see Chapter 4, Softkey SWEEP TIME MANUAL).
Example:
":SWE:TIME 10s"
Features: *RST value - (AUTO is set to ON)
SCPI: conforming
Modes: A, VA-A
If
SWEep:TIME
is directly programmed, automatic coupling is switched off.
:[SENSe<1|2>:]SWEep:TIME:AUTO ON | OFF
This command switches the automatic coupling of the sweep time for the frequency span or
bandwidth settings.
Example:
":SWE:TIME:AUTO ON"
Features: *RST value: ON
SCPI: conforming
Mode: A
If
SWEep:TIME
is directly programmed, automatic coupling is switched off.