Rockwell ArmorStratix 5700 series, Instructions Manual

Page: 425 / 548

Rockwell Automation Publication 1783-UM007F-EN-P - September 2016 425
Troubleshoot the Switch Chapter 9
Restart the Switch from the Logix Designer Application
From Module Properties dialog box within the Studio 5000 Logix Designer®
application, do the following.
1. In the navigation pane, click Module Info.
2. To perform a switch reset (power cycle) with the current configuration
file, click Reset Module.
A password prompt appears.
3. Enter your password and click Enter.
Reset the Switch to Factory Defaults
From Device Manager, do the following.
1. From the Admin menu, choose Restart/Reset.
2. Click Reset the Switch.
This option resets the switch, deletes the current configuration settings,
returns to the factory default settings, and then restarts the switch.
If you do not know the switch IP address, follow the procedure in the
Access Direct Managed Mode section on page 423 to access Direct
Managed mode.
IMPORTANT All connections to or through the switch are closed when you reset a
module. Connection loss can result in loss of control.
ATTENTION: Resetting the switch deletes all customized switch
settings, including the IP address, and returns the switch to its factory
default. The same software image is retained. To manage the switch
or display Device Manager, you must reconfigure switch settings, as
described in
Chapter 2 , and use the new IP address.
IMPORTANT Restarting the switch interrupts connectivity of your devices to the network.