Rockwell ArmorStratix 5700 series, Instructions Manual

Page: 39 / 548

Rockwell Automation Publication 1783-UM007F-EN-P - September 2016 39
Get Started Chapter 2
Configure Network Settings
via Device Manager To configure network settings via Device Manager after you run Express Setup,
follow these steps.
1. Access Device Manager, as described on page 48 .
If the Express Setup window does not appear, try the following:
• Verify that your network adapter is set to accept a DHCP address
• Enter the URL of a well-known website in your browser to be sure
that the browser is working correctly. Your browser then redirects to
Express Setup.
• Verify that any proxy settings or pop-up blockers are disabled on your
browser.
• Verify that any wireless interface is disabled on the computer.
2. On the Express Setup window, complete the fields, as described in
Table 11 .
To view fields for Common Industrial Protocol (CIP), click Advanced
Settings.